Chris Williams' Journal
Home Page: Chris W
Gosford, NSW, Australia
| Total Posts: 225 | Latest Post: 2026-01-22 |
| Table of Contents | RSS Feed |
OK, Next episode. After a general clean up with a wire cup brush:


The plan: Replace the 2 rivet posts with some internally threaded rod. I used some old broken Hex Drill bits for these, drilled out with a 11/64" (4.3mm) and tapped 5mmx0.8.


This is what is proposed:

Decided to braze rather than weld. Had some difficulty holding/supporting them in the correct place, but eventually got this:

Then with the threads cleaned up and the braze cleaned up, the screws will go in. SS, BTW. Just what I had, thinking that I'll change them to Allen head later.


A new end plate made from SS and crudly stamped ESTWING.

I'm ready to make the handle similarly to that which I did on mine. Stay tuned.


The plan: Replace the 2 rivet posts with some internally threaded rod. I used some old broken Hex Drill bits for these, drilled out with a 11/64" (4.3mm) and tapped 5mmx0.8.


This is what is proposed:

Decided to braze rather than weld. Had some difficulty holding/supporting them in the correct place, but eventually got this:

Then with the threads cleaned up and the braze cleaned up, the screws will go in. SS, BTW. Just what I had, thinking that I'll change them to Allen head later.


A new end plate made from SS and crudly stamped ESTWING.

I'm ready to make the handle similarly to that which I did on mine. Stay tuned.




No comments have been posted yet...
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free