Paul McLaren's Journal
Home Page: Paul M (RIP)
Haney, BC, Canada
| Total Posts: 8 | Latest Post: 2010-07-03 |
| Table of Contents | RSS Feed |
Pulled everthing up and removed all of the rust I Could with a wire brush on a drill and a grinder.
Installed dynamat on tunnel and firewall, sound proofing on the floor and rear bulk Head panel with aluminum foil tape on top.
Still going at it slowly just got the engine Bay painted. Also replaceing brake master, rear wheel cylinders, brake hoses, clutch master (rebuilt and slave (new),clutch hose, repacking and replacing bearings and all seals where needed. New Poly Prothane bushings on the rear end. Just put in the freshly painted Heater box and pressure tested heater core, it still had the original foam on both sides. All bullet connectors cleaned and lubed with many female ends replaced.
Next will be to replace electric oil pressure guage with a mechanical one.
a month ago.
No comments have been posted yet...
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free
a month ago.
No comments have been posted yet...
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free
a month ago.
No comments have been posted yet...
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free
No comments have been posted yet...
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free
available and if so, where ?
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free







































No comments have been posted yet...
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free